Tc-electronic M2000 Bedienungsanleitung PDF herunterladen (Seite 21)

MIDI MONITOR & TUNER

Tuner

Press Shift - Routing to access the Tuner of the M2000.

When Tuner is selected, the Outputs will be muted.

Select Guitar/Bass/Manual mode by turning the ADJUST wheel.

When Guitar or Bass is selected, the Tuner will only respond to

notes corresponding to the strings of these instruments.

When set to Manual, you must select the desired Note using the

ADJUST wheel.

In the Master section, you can Calibrate the Tuners default, 440-

445 Hz.

The detected note will be shown in the lower right corner and in

the note line. When the horizontal marker is 0, you are tuned in.

The two tuning guides will tell you wether the note is too flat or

too sharp.

Press any key to exit Tuner.

MIDI Monitor

Press Shift - Util/Midi to access MIDI Monitor.

In the MIDI Monitor, you are able to see all MIDI actions

received by the M2000. The actions are displayed according to

the current channels.

Prog. Displays Program changes.

Note Displays Note On/Off.

Cntl Displays Control changes

Sys-x Displays System exclusive commands

Eng Displays the midi channels of Eng 1,2 and combined.

Chan Displays the Midi channels

Press any key to exit MIDI Monitor.

Program changes

Channel pointer

Tuning guide

»MIDI MONITOR SCREEN«

»TUNER SCREEN«

Note on/off

Controllers

System exclusive

Engines MIDI channels

Select guitar/bass

or note set manual

Master tune 440-445Hz

Detected note

Deviation in cents

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 36 37

Keine Kommentare

Tc-electronic M2000 Bedienungsanleitung Seite 21