Tc-electronic Blacksmith Bedienungsanleitung PDF herunterladen (Seite 12)

5 – TWEETERTONE™ (in Shift Mode)

Manyheadsandcabinetsincludeaso-called“Lpad”HFcontrol

on the back side of the cabinet. This control normally sets the

level of the tweeter in the cabinet and is used to adjust the level

of high frequencies.

TweeterTone is a far more intuitive and much better way of

adjusting the high frequency content. By using TweeterTone,

youdonotsimplyturnthetweeterupanddowninlevel–you

also get a much more musical and pleasant HF adjustment. And

instead of having to fumble around on the back of the cabinet,

you can simply use the TweeterTone knob right there on the

front panel.

Finally, TweeterTone is stored as part of your presets. This

allows you to adjust the level of HF with the rest of your sound

and thus go from a round and warm vintage sound to a sparkling

andcrispslap-setting–simplybyhittingapresetswitch.

6 – TUBETONE™

TubeTone™allowsyoutoalterthe“personality”andsoundof

your BLACKSMITH. The effects you can achieve range from a

small touch of classic tube amp response and character through

obvious,butpleasant“tubeattitude”tohighlyoverdriven.

Contrary to many tube simulations, TubeTone™ recreates

both the entire preamp section (located before the tone control

section) and the power amp section (located after the tone

controls). Not only does this give you the most realistic and

flexible recreation of the actual tube sound and response,

but it also allows you to alter the behavior and character of

TubeTone™ through the BLACKSMITH tone controls as you

would on an actual tube amp.

The TUBETONE knob adjusts the amount of both the

preamp and the power-amp tube simulation.

6 – PRESET LEVEL (in Shift Mode)

Press SHIFT and then turn the TUBETONE knob to adjust

the level of the currently selected MEM/preset. When you

haven’t been using the BLACKSMITH’s front panel controls

for about twenty seconds, the LED will flash rapidly, and the

BLACKSMITH will automatically return to normal mode. In

normal mode, the TUBETONE knob controls the intensity of the

Tubetone™ effect.

Range: -12 dB to 0 dB

OPERATION – FRONT PANEL

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Keine Kommentare

Tc-electronic Blacksmith Bedienungsanleitung Seite 12