Tc-electronic Blacksmith Bedienungsanleitung PDF herunterladen (Seite 8)

QUICK SETUP GUIDE

If you just can’t wait…

Here are a few quick steps to get you playing within minutes.

Unpacking

• UnpackyourBLACKSMITHamp.

• Theboxshouldcontainthefollowingitems:

 – BLACKSMITHamplifier

 – PowerCable

 – Manual.

• Inspectallitemsforsignsoftransitdamage.Intheunlikely

event of this having occurred, inform the carrier and supplier.

• Keepallthepackagingifdamagehasoccurred,asthiswill

show evidence of excessive handling force.

• Itisalsoagoodideatokeepthepackagingforfuture

transportation.

Setting up

• ConnecttheSpeakerOutoftheamplifiertoyourcabinet

using a Speakon cable.

• Blacksmithcanrunanycabinetcombinationwithaminimum

load of 2 Ohm. To get the optimum performance from the

amplifier, make sure to select the correct Load Impedance

on the back plate before powering up the amplifier.

Notice that the amplifier will NOT be damaged if a

wrong Load Impedance setting is selected, but a

protection mode may be invoked.

(please refer to page 19 for more information)

• Connectthepowercableandpowerup.

• Connectyourbasstotheinputjackonthefrontpanel.

• AdjusttheinputgainusingtheGAINknob.

• AdjusttheoutputvolumeusingtheMASTERknob.

• Play!

• RC-4isanoptionalpedalwithfourfootswitchesthatcan

use to switch between three memory locations and also

to mute for tuning purposes. This pedal also shows tuner

information.

Be sure to check www.tcelectronic.com for latest news about

these and other TC products.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Keine Kommentare

Tc-electronic Blacksmith Bedienungsanleitung Seite 8