Tc-electronic M2000 Bedienungsanleitung PDF herunterladen (Seite 19)

Memory Protect

Protect

This parameter sets the Memory protect On or Off. When the

Protect is activated the Ram presets inside the High and Low

limit are write protected.

Low Lim

Sets the Low limit of the Memory protect. The current number is

included in the Protect.

High Lim

Sets the High limit of the Memory protect. The current number is

included in the Protect.

Snapshot Protect

Enables or disables the Protect of the Snapshots. When activated

the Snapshots are write protected.

Memory Backup

Mem > Card

Insert a PC-CARD Card in the card-slot and press OK. All Ram

presets of the M2000 will now be backed up to the Memory

Card.

Card > Mem

Insert the PC-CARD Card containing your presets and press OK.

All Presets will now be Stored back into the M2000 Ram.

Warning:

This action will destroy ALL existing Ram Presets of the M2000.

Mem > Midi

Connect your M2000s Midi Out to a another M2000, a

Sequencer or any other Midi Recordable device. Press OK and

the M2000 will perform a Midi bulk dump of all Ram Presets.

Midi > Mem

Connect the Storing device to the M2000s Midi In and press OK.

The M2000 is now ready to receive a Midi bulk dump containing

Ram presets. WARNING this action will destroy ALL existing

Ram Presets of the M2000.

Pedal

The Pedal input can control any one of four different features:

Engine 1 Bypass, Engine 2 Bypass, Engine 1+2 Bypass and Tap

tempo.

Select by turning the Adjust Wheel.

MIDI Out

Channel

Sets the sending MIDI channel of the M2000.

Filter

Sets wether the current section of the M2000 should send out

MIDI Control changes (CTRL) and MIDI Program changes

(PROG) or not; i.e., when Filter is set to PROG the M2000 will

only send out MIDI Program changes.

Offset

With this parameter you are able to add or subtract to the out-

going Program change; i.e., the outgoing Program Change is pre-

set 123, and the Offset is set to +1 the Program Change will now

be 124.

MIDI Map

Sets the current MIDI Map On or Off.

Prg. Bank

Determines which Bank the MIDI Map should control;

Ram/Rom.

Prg. In

The current Program change Maps to a M2000 program (See

Maps to).

Maps to

The current incoming Program change set in “Prg. In” will be

changed to the Program number of this parameter.

Reset Map

Press OK while this parameter is selected and your MIDI Map

will be Reset.

Security

Security Lock

Press OK while this parameter is selected to Security lock the

M2000. When locked, you will have to dial the PIN-Code shown

below to access the M2000.

PIN-Code

Set your own PIN-code for the Security lock by Dialing the

Adjust Wheel.

If you should forget your PIN-code, please enter the Reset page.

This will release M2000 from the locked state. (You do not have

to run any of the reset functions).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 36 37

Kommentare zu diesen Handbüchern

Keine Kommentare

Tc-electronic M2000 Bedienungsanleitung Seite 19

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio-Zubehör Tc-electronic M2000